Water Connection Adaptor for Plastica AG Mini Heat Pump

5 reviews for Water Connection Adaptor for Plastica AG Mini Heat Pump

1. 

   Mohammed Imran – 21st December 2022

   for any tap that has 38 tails. Straight into the valve so its very easy

2. 

   Alexandra Kraetzig – 3rd November 2022

   Absolutely perfect for what I needed these adaptors and at a reasonable price.

3. 

   DaisyGal – 11th October 2022

   Perfect for Grohe taps ……………………………….

4. 

   Mr. E Matthews – 8th June 2022

   The brass tail is too short. On compression fittings Once its done up, you cannot remove the nut to get to the olive. It is essentially impossible to PTFE over the olive due to this I know, should not be required, but I like to be able to. The threads are too big to allow the nut to slide back enough to ever replace the olive if it is leaking. Once its on, thats it. On pushfit The tail is again 510mm to short for me to confidently use it. It will just engage with the oring, at a push, but you cannot get it into a JG fitting deep enough and maintain clearance on the dismounting ring. If you have time, get this type of fitting instead 15mm Compression by 38 BSP Male Iron Thread. Screwfix do not sell it, but they should. In the end I used this and put in liquid thread sealer on top of the olive, as if this joing leaks all you can do is tighten it and hope. I will in future be planning ahead and getting the fitting I mentioned above.

5. 

   CHUMLEY – 20th April 2022

   If youre fitting Grohe taps these are the answer, 15 mm tails fit into any standard fitting